Glacier Bay JY5002113 Installation Guide download pdf (Page 8)

Care and Cleaning

□ To clean, wipe down with a damp cloth and towel dry.

Troubleshooting

Problem Possible Cause Solution

There are leaks from the

handle.

The bonnet nut has come loose and/or the

washer is dirty or damaged.

□ Tighten the bonnet nut.

□ Clean or replace the washer.

The aerator has an

irregular or reduced

water ow.

□ Remove the aerator and

check for debris.

□

Ensure that the rubber washer

is properly installed.

The water will not shut off

completely.

The rubber seat and spring is dirty or

broken.

□ Remove the cartridge to check

the rubber seat and spring.

□ Clean or replace.

The aerator is dirty or mis-tted.

□ Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will

be voided.

NOTE: Refer to the service parts section in this manual for

a detailed drawing showing the location of the parts listed

below.

Leaking from sink drain

at the base of the sink.

Rough or irregular surface on sink. □ Apply additional silicone sealant

to the beveled side of the drain

ange.

□ Retighten and test for leaks.

1 2 3 4 5 6 7 8 9 10

No comments

Glacier Bay JY5002113 Installation Guide Page 8