Glacier Bay 873W-1016 Installation Guide download pdf (Page 6)

Installation (continued)

Installing the supply

connections

□

□ Tighten the pipes to the valve body (D) with a

pipe wrench (not included).

Wrap thread sealant tape around the pipe

threads in a clockwise direction, as shown.

□

Connect the hot and cold water supply lines (1,

not included), the shower outlet pipe (2, not

included), and tub outlet pipe (3, not included)

by threading them into the valve body (D) in a

clockwise direction.

Connect the pipe elbows (4, not included) to

the end of the shower outlet and tub outlet

pipes.

□

NOTE: Be sure to position the body (D) correctly in the

wall, with the markings "UP" facing upward. The hot water

supply lines go into the H inlet, and the cold water supply

lines go into the C inlet. Do not use PEX or CPVC between

the valve and spout.

NOTE: If you do not wish to install the tub outlet, insert

the plug (I) into the bottom of the valve body (D).

Flushing the water outlets

□

and checking for leaks

Place the handle (F) on the valve body (D)

inverter and turn the handle (F) to the full on

mixed position. Turn on the hot and cold water

supply lines and allow the water to ow from

the outlets for one minute, or until all foreign

matter has been ushed out. Check for leaks.

Shut off the water at the faucet and supply

lines. Remove the handle (F) and unscrew

the screw (G).

□

HOT

COLD

HOT

COLD

1 2 3 4 5 6 7 8 9 10 11 ... 41 42

No comments

Glacier Bay 873W-1016 Installation Guide Page 6