Glacier Bay FW0C4100CP Installation Guide download pdf (Page 8)

Installation (continued)

IMPORTANT: After installation is complete, remove the

Do not lose the gasket in

the aerator.

□ Ensuring the handles are in the off position, turn

on the water supply and check for leaks. If you

discover any leaks, check your connections to

ensure they are installed properly.

□ Remove the aerator and housing (if applicable).

Turn on the hot and cold handles to allow the

water to run for at least one minute. This ushes

away any debris that could cause damage to

internal parts.

□ Turn off the water and reinstall the aerator and

housing (if applicable).

□ Remove the cap from the quick connect tubes.

□ Attach the quick connecting hose (J) connections

to the hot faucet handle (B) connection, faucet

body (A) connection, and cold faucet handle (K)

connection. Push until the connections snap

together.

□ Pull down moderately to ensure the connection

has been made.

Attaching the quick connecting

hose

Flushing and checking for leaks

Connecting the supply lines

Use 1/2 in. I.P.S. faucet connections (1), or a

3/8 in. O.D. ball-nose riser (2) with supply line

coupling nuts (3) (not included).

Use two wrenches to tighten the connections.

Do not over tighten or torque the copper supply

line.

Operation

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 21 22

No comments

Glacier Bay FW0C4100CP Installation Guide Page 8