Glacier Bay 67552-1008D2 Installation Guide download pdf (Page 5)

HOMEDEPOT.COM/GLACIERBAY

Please contact 1-855-HD-GLACIER for further assistance.

Installation (continued)

Installing the faucet assembly

□ Place the faucet (A) through the mounting holes

in the sink.

□ Secure the faucet (A) to the sink using the

mounting nuts (C) provided. Hand tighten only.

NOTE: If the sink is uneven, use silicone under the

gasket (B).

Operation

Flushing and checking for leaks

□ Ensuring the handles are in the off position, turn

on the water supply and check for leaks. If you

discover any leaks, check your connections to

ensure they are installed properly.

□ Remove the aerator and housing (if applicable).

Turn on the hot and cold handles to allow the

water to run for at least one minute. This

ushes away any debris that could cause

damage to internal parts.

□ Turn off the water and reinstall the aerator and

housing (if applicable).

IMPORTANT: After installation is complete, remove the

aerator to ush the water lines. Do not lose the gasket (1)

in the aerator.

Making the water supply

connections

NOTE: The hot side inlet tube is indicated by a label.

If the label is not present, the hot supply tube is the longer

of the two inlet tubes.

□ Use 1/2 in. I.P.S. faucet connections (2), or use

supply line coupling nuts (3) (not included) with

a 3/8 in. O.D. ball-nose riser (1).

NOTE: Before tightening the faucet connector to the water

supply, apply a second wrench to the supply tube tting.

This will prevent the supply tube from moving or twisting

when tightening the faucet connector. Do not overtighten.

1 2 3 4 5 6 7 8 9 10 ... 15 16

No comments

Glacier Bay 67552-1008D2 Installation Guide Page 5